Speco Technologies D16RS Manual do Utilizador descarregar pdf (Página 26)

4-4. Setup – DEVICE Mode

In the SETUP menu, select the DEVICE tab. Then, the device menu is displayed as pictured below.

Navigate through the menu items using the mouse or the control button on the remote control and change

the value of the menu item.

Figure 4.4.1. DEVICE Setup Screen

Table 4.4.1. Menu Items in DEVICE Setup Screen

Item

Description

ALARM OUT

Set the sensor, motion, and video loss for triggering alarm relay

HDD Error and Video Loss can trigger beeping.

(D4RS does not support ALARM OUT.)

CONTROLLER &

PTZ

Set the PTZ baud rate, protocol, and ID.

(D4RS does not support CONTROLLER & PTZ.)

SPOT-OUT

D4RS/D4WRS: CVBS OUT is switchable as Composite Video Output

or Spot-Out according to the resolution of VIDEO OUTPUT (VGA).

D8RS/D16RS/D8WRS/D16WRS: CVBS1 – Composite Video Output /

CVBS2 – Spot-Out.

SITE

Select specified channel for motion zone setup.

MOTION ZONE

Select either Full Zone or Partial Zone for motion detection.

MOTION

Set the motion sensitivity for the selected channel.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 93 94

Sem comentários

Speco Technologies D16RS Manual do Utilizador Página 26